Huawei LUNA2000-5-S0 - 6.3.2 Installing DC Input Power Cables

NO TE
● It is recommended that silica gel or paint be used around the ground terminal after the
PE cable is connected.
----End
6.3.2 Installing DC Input Power Cables
Connect DC input power cables to the inverter
Insert the positive and negative battery connectors (Staubli) into the
corresponding DC input terminals (BAT+ and BAT–).
NO TE
The DC input terminals (BAT+ and BAT–) on the left and right sides of the battery are the
same.
Step 1 Assemble DC connectors.
Figure 6-11 Assembling DC connectors
CA UTION
For battery terminals, use the delivered Staubli MC4 positive and negative metal
terminals and DC connectors. Using incompatible positive and negative metal
terminals and DC connectors may burn the cables or damage the module. The
resulting device damage will not be covered under warranty.
LUNA2000-(5-30)-S0
User Manual 6 Electrical Connection
Issue 15 (2024-01-12) Copyright © Huawei Digital Power Technologies Co., Ltd. 89