Huawei MA5600 - 256 multicast channels cant be online at the same time in 5680 T

NGN Cases Chapter 3 GPON FTTx Cases
Confidential Information of Huawei. No Spreading without Permission
42
connected to packet generator tool 2.Check the patchcord, the result is OK.
3.Try loopback ETHB Port, the result is OK.
4. in this case, ETHB is in the slot 0/17.
OLT (ETHB Port 1) --> Packet generator tool (GE port)--> OLT (GICF Port 1)
Alarm Informatio
n:
Null
Cause Analysi
s:
The Board is in the isolate state
Handling Proces
s:
In this case, ETHB is in the slot 0/17.
Using command,
get into interface ETHB
#undo isolate board 0/17
Suggestions and
Summary:
Null
3.2 256 multicast channels can't be online at the same time in 5680T
Title:
256 multicast channels can't be online at the same time in 5680T
ID: SE0000385483
Information
Type :
Troubleshooting Cases Quality Level:
C
Product Family:
Optical Access
Product:
MA5680T
Fault Type:
Multicast Service
Keywords: Enable MA5680T Multicast bandwidth
Permission
Level:
04Common Users Permission
Phenomenon
Descriptio
n:
Configure MA5680T using 3 ONT (2xHG865 and 1xHG863).
When doing test, packet generator is used to generate IGMP packets as IGMP programs.
The result is that only 128 multicast channels can be online at the same time.
MA5680T-->Packet generator -->HG865+HG863
Alarm Inform
ation:
Null
Cause Analy
sis:
Check configuration of multicast but it's OK .
The conclusion is there is not enough multicast bandwidth .
Handling Pr
ocess:
MA5600T(config)#btv
MA5600T(config-btv)#igmp bandwidthcAC
{ bandwidthswitch<E><enable,disable> }:disable
Command:
igmp bandwidthcAC disable
Are you sure to disable the bandwidth management?(y/n)[n]:y
MA5600T(config-btv)#quit
MA5600T(config)#
Suggestions
and Summa
ry:
Null