NGN Cases Chapter 3 GPON FTTx Cases
Confidential Information of Huawei. No Spreading without Permission
46
Phenomenon De
scription:
Q:
Different FE ports on the MA562xG are separated by default. How to implement the
interworking between different FE ports in one VLAN at layer 2?
Alarm Informatio
n:
Null
Cause Analysi
s:
Null
Handling Proces
s:
A:
Run the undo isolate port command to implement the interworking. For example, run the
following commands to cancel the separation between ports 0/1/1 and 0/1/2 so that ports
0/1/1 and 0/1/2 can communicate with each other:
MA5626(config)#undo isolate port 0/1/1
MA5626(config)#undo isolate port 0/1/2
3.7 The Interconnection Between the Switch of Company C and MA5600T Fails Because
the LACP Configuration of the Switch of Company C Is Incorrect
Title:
The Interconnection Between the Switch of Company C and MA5600T Fails
Because the LACP Configuration of the Switch of Company C Is Incorrect
ID: SE0000374363
Information
Type :
Troubleshooting Cases Quality Level:
C
Product Family:
Optical Access
Product:
MA5600T Series
Fault Type:
Equipment Interconnection
Keywords: Switch 6500 of company C, MA5600T, LACP
Permission
Level:
03Equipment Users Permission
Phenomenon De
scription:
In an oversea commercial office, the customer requests that Huawei MA5600T must be
connected upstream to the switch 6500 of company C in the lacp-static mode. After the
lacp-static mode is configured normally as follows, alarms are generated and services
fail.
MA5680T(config)#link-aggregation 0/17 0-1egress-ingress workmode lacp-static
MA5680T(config)#display link-aggregation all
---------------------------------------------------------------------
Master port Link-aggregation mode Port NUM Work mode
---------------------------------------------------------------------
0/17/0 egress-ingress 2 lacp-static
---------------------------------------------------------------------
Total: 1 link-aggregation(s)
To Next Page
