Huawei Quidway S2700 series - Example for Configuring the Interconnection of FTP Servers and Devices in and out of the HGMP Cluster; (In NAT Mode)

#
return
3.6.2 Example for Configuring the Interconnection of FTP Servers
and Devices in and out of the HGMP Cluster (in NAT Mode)
Networking Requirements
As shown in Figure 3-4, all the Layer 2 switches belong to the same cluster. Administrator-1 is
the administrator switch of the cluster and other switches are member switches. The member ID
of Member-1 is 1, the member ID of Member-2 is 2 and the member ID of Member-3 is 3.
To upload files to Member-1, Member-2, and Member-3 or download files from them, you can
set up an FTP connection between the devices out of the cluster and member switches in NAT
or non-NAT mode.
NOTE
In this configuration example where the NAT mode is adopted, Member-3 accesses the FTP server
(2.0.0.1/8) out of the cluster and devices out of the cluster access the FTP server (Member-2) in the cluster.
Figure 3-4 Networking diagram of configuring the interconnection of FTP servers and devices
in and out of the HGMP cluster (in NAT Mode)
IP/MPLS
core
......
FTP Server
2.0.0.1/8
SFTP Server
2.0.0.2/8
NM station
3.0.0.1/8
Log station
4.0.0.1/8
Administrator-1
10.0.0.1/8
Member-1
Member-2
Member-3
10.0.0.4/8
Ethernet0/0/1 Ethernet0/0/2
Ethernet0/0/1
Ethernet0/0/2
Ethernet0/0/1
Ethernet0/0/1
Cluster
Ethernet0/0/3
Ethernet0/0/1
1.0.0.2/8
Device
MAC Address Device MAC Address
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
119