Huawei Quidway S2700 series Configuration Guide

No. Data
1 Administrator name and test name
2 Round-trip transmission delay threshold
6.16.2 Configuring Round-Trip Delay Thresholds
This part describes how to set a round-trip transmission delay threshold. When the transmission
duration exceeds the threshold, a trap message is sent to the Network Management System
(NMS).
Context
Do as follows on the switch to perform the NQA test:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the NQA instance view is displayed.
Step 3 Run:
test-type test-type
The test type is configured.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional)Run:
destination-port port-number
The destination port number is configured.
Step 6 Run:
threshold rtd rtd-value
The round-trip transmission delay threshold is configured.
Step 7 Run:
send-trap rtd
The trap function is enabled.
----End
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
296

Huawei Quidway S2700 series Specifications

General

Brand	Huawei
Model	Quidway S2700 series
Category	Switch
Language	English