EasyManua.ls Logo

Huawei Quidway S2700 series - Checking the Configuration

Huawei Quidway S2700 series
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Step 5 Run the following commands as required ( For detailed parameter configurations, see the chapter
Configuring Universal NQA Test Parameters ):
l To configure the maximum hops, run:
tracert-hopfailtimes times
l To configure the initial TTL and maximum TTL values of a packet, run:
tracert-livetime first-ttl first-ttl max-ttl max-ttl
l To configure the source IP address, run:
source-address ipv4 ip-address
l To configure the destination port number, run:
destination-port port-number
l To configure a NQA test packets to be sent without searching the routing table, run:
sendpacket passroute
Step 6 Run:
start
An NQA test is started.
Select the start mode as required because the start command has several forms.
l To start the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ] hh:mm:ss |
delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started immediately.
l To start the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss [ end
{ at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds
second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
l To start the NQA test after a certain delay, run the start delay { seconds second |
hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
----End
6.10.3 Checking the Configuration
After configuring a traceroute test, you can view the test result.
Prerequisite
The configurations of the traceroute test are complete.
Context
NOTE
NQA test results cannot be displayed automatically on the terminal. You need to run the display nqa
results command to view test results. By the default, the command output contains the records about only
the last five tests.
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
275

Table of Contents

Other manuals for Huawei Quidway S2700 series

Related product manuals