Huawei Quidway S2700 series - Example for Configuring the FTP Upload Test

ftp-password hello
ftp-filename test.txt
ftp-operation get
#
return
l Configuration file of Switch B
#
sysname SwitchB
#
vlan batch 10
#
interface Vlanif10
ip address 10.1.1.2 255.255.255.0
#
interface Ethernet0/0/1
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
FTP server enable
#
aaa
local-user user1 password cipher 3MQ*TZ,O3KCQ=^Q`MAF4<1!!
local-user user1 service-type ftp
local-user user1 ftp-directory flash:
#
return
6.19.3 Example for Configuring the FTP Upload Test
Networking Requirements
As shown in Figure 6-5:
You are required to test the speed of uploading a file from Switch C to the FTP server.
Figure 6-5 Networking diagram for configuring the FTP upload test
SwitchA
SwitchB
Ethernet
0/0/1
VLANIF10
10.1.1.1/24
Ethernet
0/0/1
VLANIF20
10.2.1.1/24
FTP
Client
SwitchC
Ethernet
0/0/2
VLANIF10
10.1.1.2/24
Ethernet
0/0/2
VLANIF20
10.2.1.2/24
FTP
Server
Configuration Roadmap
The configuration roadmap is as follows:
1. Configure Switch A as the NQA client and the FTP client. Create and perform the FTP test
on Switch A to check whether a connection between Switch A and the FTP server can be
set up and to test the time for uploading a file to the FTP server.
2. A user with the name user1 and the password hello logs in to the FTP server to upload a
file whose size is 10k.
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
308