Huawei Quidway S2700 series - Example for Configuring the Test of Sending NQA Threshold Traps to the NMS

port hybrid untagged vlan 110
#
nqa-server udpecho 10.2.1.2 9000
#
ip route-static 10.1.1.0 255.255.255.0 10.2.1.1
#
return
6.19.11 Example for Configuring the Test of Sending NQA
Threshold Traps to the NMS
Networking Requirements
As shown in Figure 6-13, the trap threshold are configured and the function of sending trap
messages is enabled when a Jitter test is configured. After the Jitter test is complete, Switch A
sends a trap message to the NMS when the interval for transmitting the test packet from
Switch A to Switch C or from Switch C to Switch A exceeds the configured unidirectional
transmission threshold, or when the RTT of the test packet exceeds the configured bidirectional
transmission threshold. Network administrators can view the cause of a trap in the trap message
received by the NMS.
Figure 6-13 Network diagram for configuring the NQA threshold
NQA Server
NM Station
Ethernet0/0/1
VLANIF120
10.1.1.1/24
Ethernet0/0/1
VLANIF120
10.1.1.2/24
Ethernet0/0/1
VLANIF130
30.1.1.2/24
Ethernet0/0/2
VLANIF130
30.1.1.1/24
Ethernet0/0/2
20.1.1.2/24
SwitchA
SwitchB
SwitchC
VLANIF110
20.1.1.1/24
NOTE
For the information about clock synchronization, see "NTP" in the Quidway S2700 Series Ethernet
Switches Feature Description - Network Management.
Configuration Roadmap
The configuration roadmap is as follows:
1. Configure a Jitter test.
2. Configure the NQA thresholds.
3. Enable the function of sending trap messages.
4. Configure the function of sending trap messages to the NMS.
Data Preparation
To complete the configuration, you need the following data:
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
326