Huawei Quidway S2700 series - Configuring Parameters for a Traceroute Test

Applicable Environment
An NQA Traceroute test can provide functions similar to those provided by the tracert
command, but outputs more detailed information.
Pre-configuration Tasks
Before configuring a traceroute test, configure reachable routes between the NQA client and the
device to be tested.
Data Preparation
To configure a traceroute test, you need the following data.
No. Data
1 Administrator and name of an NQA test instance
2 Destination IP address
3 (Optional) maximum hops, initial TTL and maximum TTL value of the packet, and
source IP address and destination port of the packet
4 Start and end modes of a test
6.10.2 Configuring Parameters for a Traceroute Test
This part describes how to configure parameters for a traceroute test.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type trace
A traceroute test is created.
Step 4 Run:
destination-address ipv4 ip-address
The destination address of the traceroute test is configured.
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
274