Huawei Quidway S2700 series - Configuring the SNMP Query Test Parameters

No. Data
1 Administrator name and test name
2 IP address of the SNMP agent
3 (Optional) Source IP addresses and source port numbers of test packets, interval for
sending test packets, and percentage of the failed NQA tests
4 Start mode and end mode of the test
6.11.2 Configuring the SNMP Query Test Parameters
This part describes how to set SNMP query test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type snmp
The test type is set to SNMP Query.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address, that is, the IP address of the SNMP agent, is configured.
NOTE
The SNMP function must be enabled on the destination host; otherwise, the destination host fails to receive
Echo packets.
Step 5 (Optional) Perform the following as required to configure other parameters for the SNMP test
( For detailed parameter configurations, see the chapter Configuring Universal NQA Test
Parameters ):
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the source port number, run the source-port port-numbercommand.
l To configure the interval for sending test packets, run the interval seconds interval
command.
l To configure the percentage of the failed NQA tests, run the fail-percent percent command.
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
277