Huawei Quidway S2700 series - Clearing NQA Statistics; Debugging NQA

Step 3 Run the restart command in the NQA instance view to restart an NQA test instance.
----End
6.18.2 Clearing NQA Statistics
When the statistics on the current test instance are saved to the FTP server, you can clear test
results on the device.
Prerequisite
NQA statistics cannot be restored after you clear them. So, confirm the action before you use
the command.
Context
NOTE
Statistics about the test being performed cannot be cleared.
Procedure
Step 1 Run the system-view command, enter the system view.
Step 2 Run the nqa test-instance admin-name test-name command, enter the NQA test instance view.
Step 3 Run the clear-records command in the NQA view to clear history statistics on NQA tests and
test results.
----End
6.18.3 Debugging NQA
This part describes how to debug test instances.
Prerequisite
When a fault occurs, run the following debugging command in the user view to debug NQA
and locate the fault.
Context
CAUTION
Debugging affects the performance of the system. So, after debugging, run the undo debugging
all command to disable it immediately.
Procedure
Step 1 Run the debugging nqa all command in the NQA view to enable NQA debugging.
----End
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
303