Huawei Quidway S2700 series - Example for Configuring the Traceroute Test

Send operation times: 1 Receive response times: 1
Completion:success RTD OverThresholds number: 0
Attempts number:1 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Destination ip address:
10.3.1.1
Min/Max/Average Completion Time: 1/1/1
Sum/Square-Sum Completion Time: 1/1
Last Good Probe Time: 2009-2-3 10:52:5.7
Lost packet ratio: 0 %
----End
Configuration Files
Configuration file of Switch
#
sysname Quidway
#
dns server 10.3.1.1
#
vlan batch 100
#
interface Vlanif100
ip address 10.1.1.1 255.255.255.0
#
interface Ethernet0/0/1
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
nqa test-instance admin dns
test-type dns
destination-address url server.com
dns-server ipv4 10.3.1.1
#
ip route-static 10.3.1.0 255.255.255.0 10.1.1.2
#
return
6.19.6 Example for Configuring the Traceroute Test
Networking Requirements
As shown in Figure 6-8:
The traceroute test is used to check the IP address of the VLANIF 110 interface of Switch C on
Switch A.
Figure 6-8 Networking diagram for configuring the traceroute test
SwitchA
Ethernet
0/0/1
VLANIF100
10.1.1.1/24
VLANIF100
10.1.1.2/24
VLANIF110
10.2.1.2/24
VLANIF110
10.2.1.1/24
Ethernet
0/0/1
Ethernet
0/0/1
Ethernet
0/0/2
SwitchCSwitchB
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
314