Huawei Quidway S2700 series - Configuration Examples; Example for Configuring the ICMP Test

To Next Page

To Previous Page

6.19 Configuration Examples

This section provides several configuration examples of NQA.

6.19.1 Example for Configuring the ICMP Test

Networking Requirements

As shown in Figure 6-3, Switch A and Switch B must be connected at Layer 3 through the

VLANIF interface.

Switch A functions as the NQA client to check whether Switch B is reachable.

Figure 6-3 Networking diagram for configuring the ICMP test

Ethernet0/0/1

VLANIF10

10.1.1.1/24

VLANIF10

10.1.1.2/24

Ethernet0/0/1

SwitchA

SwitchB

NQA agent

Configuration Roadmap

The configuration roadmap is as follows:

1. Perform the NQA ICMP test to check whether the route between the local end (Switch A)

and the specified destination end (Switch B) is reachable and check the RTT of a test packet.

Data Preparation

To complete the configuration, you need the following data:

l Host address of Switch B

Procedure

Step 1 Create a VLAN and add interfaces to the VLAN.

# Configure Switch A.

<Quidway> system-view

[Quidway] sysname SwitchA

[SwitchA] vlan 10

[SwitchA-Vlan10] quit

[SwitchA] interface ethernet 0/0/1

[SwitchA-Ethernet0/0/1] port hybrid pvid vlan 10

[SwitchA-Ethernet0/0/1] port hybrid untagged vlan 10

[SwitchA-Ethernet0/0/1] quit

# Configure Switch B.

<Quidway> system-view

[Quidway] sysname SwitchB

Quidway S2700 Series Ethernet Switches

Configuration Guide - Network Management 6 NQA Configuration

Issue 01 (2011-07-15) Huawei Proprietary and Confidential

304

Other manuals for Huawei Quidway S2700 series