Huawei Quidway S2700 series - Configuring the FTP Download Test Parameters

No. Data
1 Administrator name and test name
2 IP address of the FTP server
3 (Optional) Source IP address of the FTP operation and source and destination port
numbers of the FTP operation
4 FTP user name and password
5 Name of the file to be downloaded
6 Start mode and end mode of the test
6.6.2 Configuring the FTP Download Test Parameters
This part describes how to set parameters for the FTP download test.
Context
Do as follows on the NQA client (FTP client):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type ftp
The test type is set to FTP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other parameters of the FTP Download
test ( For detailed parameter configurations, see the chapter Configuring Universal NQA Test
Parameters ):
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the FTP source port number, run the source-port port-numbercommand.
l To configure the FTP destination port number, run the destination-port port-number
command.
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 6 NQA Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
262