Huawei Quidway S2700 series - Page 143

[Member-1-Ethernet0/0/1] ntdp enable
[Member-1-Ethernet0/0/1] quit
[Member-1] interface ethernet 0/0/2
[Member-1-Ethernet0/0/2] ntdp enable
[Member-1-Ethernet0/0/2] quit
# Configure member switch 2.
[Member-2] ntdp enable
[Member-2] ntdp timer 10
[Member-2] ntdp hop 3
[Member-2] interface ethernet 0/0/1
[Member-2-Ethernet0/0/1] ntdp enable
[Member-2-Ethernet0/0/1] quit
# Configure member switch 3.
[Member-3] ntdp enable
[Member-3] ntdp timer 10
[Member-3] ntdp hop 3
[Member-3] interface ethernet 0/0/1
[Member-3-Ethernet0/0/1] ntdp enable
[Member-3-Ethernet0/0/1] quit
After the previous configuration, globally check the NTDP configuration on the administrator
switch. You can find that the interval and range for NTDP to collect topologies is 10 minutes
and 3 hops respectively.
[Administrator-1] display ntdp
Network topology discovery protocol is enabled
Hops : 3
Timer : 10 min
Hop Delay : 200 ms
Port Delay: 20 ms
Total time for last collection:0 ms
Step 4 Enable the cluster function and set the management VLAN.
# Configure the administrator switch.
[Administrator-1] cluster enable
[Administrator-1] cluster
[Administrator-1-cluster] mngvlanid 10
[Administrator-1-cluster] quit
# Configure member switch 1.
[Member-1] cluster enable
[Member-1] cluster
[Member-1-cluster] mngvlanid 10
[Member-1-cluster] quit
# Configure member switch 2.
[Member-2] cluster enable
[Member-2] cluster
[Member-2-cluster] mngvlanid 10
[Member-2-cluster] quit
# Configure member switch 3.
[Member-3] cluster enable
[Member-3] cluster
[Member-3-cluster] mngvlanid 10
[Member-3-cluster] quit
After the topology collection function is enabled manually on the administrator switch, check
the device information collected through NTDP and you can find the MAC address and types
of related devices.
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
133