EasyManua.ls Logo

Huawei Quidway S2700 series - Page 160

Huawei Quidway S2700 series
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Data Preparation
To complete the configuration, you need the following data:
l Management VLAN ID of the cluster, that is 10
l IP address of the SNMP host, that is 3.0.0.1/8
l IP address of VLANIF 10 that is 1.0.0.1/8 and a reachable route between VLANIF 10 and
the SNMP host
l Address pool of the cluster, that is 10.0.0.0/8
l IP address of the administrator switch used in the cluster, that is 10.0.0.1/8
Procedure
Step 1 Configure a management VLAN.
# Create VLAN 10 on the device and add interfaces of the administrator switch and member
switches to VLAN 10.
# Configure the administrator switch.
<Quidway> system-view
[Quidway] sysname Administrator-1
[Administrator-1] vlan 10
[Administrator-1-vlan10] quit
[Administrator-1] interface ethernet 0/0/1
[Administrator-1-Ethernet0/0/1] port link-type trunk
[Administrator-1-Ethernet0/0/1] port trunk allow-pass vlan 10
[Administrator-1-Ethernet0/0/1] quit
[Administrator-1] interface ethernet 0/0/2
[Administrator-1-Ethernet0/0/2] port link-type trunk
[Administrator-1-Ethernet0/0/2] port trunk allow-pass vlan 10
[Administrator-1-Ethernet0/0/2] quit
[Administrator-1] interface ethernet 0/0/3
[Administrator-1-Ethernet0/0/3] port link-type trunk
[Administrator-1-Ethernet0/0/3] port trunk allow-pass vlan 10
[Administrator-1-Ethernet0/0/3] quit
[Administrator-1] interface vlanif 10
[Administrator-1-Vlanif10] quit
# Configure member switch 1.
<Quidway> system-view
[Quidway] sysname Member-1
[Member-1] vlan 10
[Member-1-vlan10] quit
[Member-1] interface ethernet 0/0/1
[Member-1-Ethernet0/0/1] port link-type trunk
[Member-1-Ethernet0/0/1] port trunk allow-pass vlan 10
[Member-1-Ethernet0/0/1] quit
[Member-1] interface ethernet 0/0/2
[Member-1-Ethernet0/0/2] port link-type trunk
[Member-1-Ethernet0/0/2] port trunk allow-pass vlan 10
[Member-1-Ethernet0/0/2] quit
[Member-1] interface vlanif 10
[Member-1-Vlanif10] quit
# Configure member switch 2.
<Quidway> system-view
[Quidway] sysname Member-2
[Member-2] vlan 10
[Member-2-vlan10] quit
[Member-2] interface ethernet 0/0/1
[Member-2-Ethernet0/0/1] port link-type trunk
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
150

Table of Contents

Other manuals for Huawei Quidway S2700 series

Related product manuals