Configuration Roadmap
The configuration roadmap is as follows:
1. Create a cluster according to the steps described in 3.6.1 Example for Configuring Basic
HGMP Functions for a Cluster.
2. 3.6.1 Example for Configuring Basic HGMP Functions for a Cluster
NOTE
l Configure the interconnection of FTP servers and devices in and out of the HGMP cluster in
NAT or non-NAT mode. The following takes the configuration in NAT mode as an example.
l If the system software, patch files, or configuration files, batch distribution can be distributed in
batches without accessing the FTP server out of the cluster, you can skip this step.
3. Configure batch distribution on the administrator switch.
Data Preparation
To complete the configuration, you need the following data:
l Management VLAN ID of the cluster, that is 10
l IP address of VLANIF 10 that is 1.0.0.1/8 and a reachable route between VLANIF 10 and
the FTP server
l Address pool of the cluster, that is 10.0.0.0/8
l IP address of the administrator switch used in the cluster, that is 10.0.0.1/8
l Member ID of Member-2 being 2 and member ID of Member-3 being 3
Procedure
Step 1 Configure a management VLAN.
# Create VLAN 10 on the device and add interfaces of the administrator switch and member
switches to VLAN 10.
# Configure the administrator switch.
<Quidway> system-view
[Quidway] sysname Administrator-1
[Administrator-1] vlan 10
[Administrator-1-vlan10] quit
[Administrator-1] interface ethernet 0/0/1
[Administrator-1-Ethernet0/0/1] port link-type trunk
[Administrator-1-Ethernet0/0/1] port trunk allow-pass vlan 10
[Administrator-1-Ethernet0/0/1] quit
[Administrator-1] interface ethernet 0/0/2
[Administrator-1-Ethernet0/0/2] port link-type trunk
[Administrator-1-Ethernet0/0/2] port trunk allow-pass vlan 10
[Administrator-1-Ethernet0/0/2] quit
[Administrator-1] interface ethernet 0/0/3
[Administrator-1-Ethernet0/0/3] port link-type trunk
[Administrator-1-Ethernet0/0/3] port trunk allow-pass vlan 10
[Administrator-1-Ethernet0/0/3] quit
[Administrator-1] interface vlanif 10
[Administrator-1-Vlanif10] quit
# Configure member switch 1.
<Quidway> system-view
[Quidway] sysname Member-1
[Member-1] vlan 10
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
160
To Next Page
Loading...
