Huawei Quidway S2700 series - Page 186

IP pool:10.0.0.1/8
Logging host:4.0.0.1
SNMP host:3.0.0.1
FTP server:2.0.0.1
SFTP server:2.0.0.2
cluster-member ftp-timeout: 300 sec(default)
Cluster SNMP NAT capability : enabled
Cluster FTP NAT capability : enabled
There are 4 member(s) in the cluster, and 0 of them are down.
Step 10 Restart member switches in batches.
# Run the cluster-member reboot group-by member-number 2 to 3 command on the
administrator switch to restart Member-2 and Member-3.
[HUAWEI_0.Administrator-1] cluster
[HUAWEI_0.Administrator-1-cluster] cluster-member reboot group-by member-number 2
to 3
Info: This command will take members reboot.
Are you sure?[Y/N]y
Step 11 Verify the configuration.
Run the display member-reboot-stat command on administrator switch to check the restart
status of the member switches, and you can view that success is displayed, which indicates that
the specified member switches are restarted successfully.
[HUAWEI_2.Member-2] display member-reboot-stat
The result of member switchs rebooting:
------------------------------------------------------------------------
SN Device MacAddress IPAddress Result
------------------------------------------------------------------------
1 S2700 0003-0003-0003 10.0.0.3 success
2 S2700 0004-0004-0004 10.0.0.4 success
----End
Configuration Files
l Configuration file of Administrator-1.
#
sysname Administrator-1
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
ip address 1.0.0.1 255.0.0.0
#
interface Ethernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
interface Ethernet0/0/2
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
interface Ethernet0/0/3
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 3 HGMP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
176