Huawei Quidway S2700 series - Page 74

[SwitchA] bpdu enable
# Configure SwitchB.
[SwitchB] bpdu enable
Step 3 Configure management addresses for SwitchA and SwitchB.
# Configure SwitchA.
[SwitchA] lldp management-address 10.10.10.1
# Configure SwitchB.
[SwitchB] lldp management-address 10.10.10.2
Step 4 Enable the LLDP trap function on SwitchA and SwitchB.
# Configure SwitchA.
[SwitchA] snmp-agent trap enable feature-name lldptrap
# Configure SwitchB.
[SwitchB] snmp-agent trap enable feature-name lldptrap
Step 5 Verify the configuration.
# Check whether the LLDP function is enabled, management addresses are configured, and the
LLDP trap function is enabled.
l View the configurations on SwitchA.
[SwitchA] display lldp local
System
information
Chassis
type :macAddress
Chassis ID :00e0-
fc33-0011
System name :SwitchA
System description :Quidway
Huawei Versatile Routing Platform
Software
VRP (R) Software, Version 5.70 (S2700 V200R006C00)
Copyright (c) 2003-2010 Huawei Technologies Co.,
Ltd
System capabilities
supported :bridge
System capabilities
enabled :bridge
LLDP Up time :2009/2/13
18:31:37
MED system information
Device class :Network Connectivity
(MED inventory information of master board)
HardwareRev :VER B
FirmwareRev :NC
SoftwareRev :Version 5.70 V200R006C00
SerialNum :NA
Manufacturer name :NA
Model name :NA
Asset tracking identifier :NA
System configuration
LLDP Status :enabled (default is disabled)
LLDP Message Tx Interval :30 (default is 30s)
LLDP Message Tx Hold Multiplier :4 (default is 4)
Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management 2 LLDP Configuration
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
64