2. Use the Left and Right arrows to access the item Bluetooth and press Confirm.
The menu contains the following items:
• Toggle Bluetooth on or off
• Connected Devices
• Paired Devices
• Pair New Device
2.3.1 Toggle Bluetooth
In the Bluetooth Settings menu, use the Left and Right arrows to navigate to the Toggle Bluetooth
item. Press Confirm to toggle the Bluetooth feature on or off.
2.3.2 Pair a New Bluetooth Device
Make sure the Bluetooth device you try to pair the StellarTrek with is turned on.
1. Use the Left and Right arrows to select the Pair New Device item in the Bluetooth Settings
menu and press Confirm.
2. The StellarTrek will start scanning for available Bluetooth devices nearby and announce all
the devices discovered.
Note that the StellarTrek will scan for devices for 15 seconds. If no device is found, the
device will prompt “Start Bluetooth device discovery”. Press Confirm to launch another
scan or Back to go back to the Bluetooth menu.
3. Navigate to the device of your choice using the Left and Right arrows, then press Confirm
to pair with it. You will receive confirmation once you are paired.
Note that the device you are trying to pair to the StellarTrek might have to be put into Pairing Mode.
Some devices may require a PIN in order to be paired. If this is the case, the StellarTrek will
announce the PIN to be entered on the device, which can be done using the text-entry method (see
section 2.2).
Once you pair with a Bluetooth device, the StellarTrek will automatically connect to it each time you
turn on the device.
2.3.3 Connect to a Bluetooth Device
If you wish to connect to a Bluetooth device that your StellarTrek is paired with, select the Paired
Devices item in the Bluetooth settings menu. Upon selecting this sub-menu, the StellarTrek will
display the list of all the Bluetooth devices you are paired with. Navigate to the device of your choice
using the Left and Right arrows, then press Confirm to connect to it. You will receive confirmation
once you are connected.
Once you connect with a Bluetooth device, the StellarTrek will automatically connect to it each time
you turn on the device.
2.3.4 Disconnect from a Bluetooth Device
If you wish to disconnect from Bluetooth device, select the Connected Devices item. Upon selecting
this sub-menu, the StellarTrek will display the list of all the Bluetooth devices you are connected to.
Navigate to the device of your choice using the Left and Right arrows, then press the Up or Down
arrow to reach the item Disconnect. Press Confirm to disconnect from the paired device. You will
receive confirmation once you are disconnected.
To Next Page
Loading...