1 Overview of StellarTrek
1.1 Unpacking the Device
The package contains the following items:
• StellarTrek device
• USB-C cable
• Power adaptor
• Belt clip and lanyard
• Getting started sheet
1.2 Physical Description of StellarTrek
1.2.1 Front Face of the Device
On the front side of the device, at the center, are nine buttons. The two upper buttons are the Back
button (left) and the Go to button (right). To the left of the Back button is a small hole. This is the
microphone.
Below the Back button and the Go to button are four arrow keys -Left, Right, Up and Down-
centered by a Confirm button. The Left and Right arrows are generally used to navigate through
a menu; while the Up and Down arrows are used to navigate in the contextual menu options of an
item.
The two lower buttons are the Where Am I? button (left) and the Voice button (right). Finally, at
the bottom of the front face of the device, is a speaker in the form of an indent.
1.2.2 Left Side of the Device
On the upper left side of the device are two buttons. These are the Up and Down volume buttons
used to increase or decrease the volume. For your convenience, separate volume settings are
saved for the built-in speaker and headphones.
1.2.3 Right Side of the Device
On the right side of the device, near the top corner, is the Power/Sleep Toggle button. Press and
hold this button until it vibrates, then release it, to power on. Below the Power button is a LED
indicator. This LED turns on when the StellarTrek is plugged into a power supply. The LED is
colored red when the battery level is below 15%, orange when the battery level is between 15 and
90%, and green when the battery level is above 90%.
Below the power button and the LED is the Record button which has a red circle painted on it with
a raised dot in the middle.
1.2.4 Bottom Edge of the Device
At the right of the bottom edge of the StellarTrek is a 3.5mm audio jack. You can use the device
with headphones, which will take over the speaker when plugged in.
In the center of the bottom edge is the USB-C port. Use this port to recharge the device or to access
content on the device’s internal storage using the included USB cable.
To Next Page
Loading...