3.6.2 Sort Landmarks
When landmarks have been created, you can sort them by city, by proximity, by last used and by
creation date:
1. Press the Go To button. The StellarTrek will announce: “Select a landmark as your
destination”.
2. Use the Left and Right arrows to reach the item Sort.
3. Use the Up and Down arrows to select the category under which you wish to sort your
landmarks. The categories are: Sort by proximity, Sort by last used, Sort by city and Sort
by creation date. Press Confirm to select the category. The StellarTrek will announce the
first element in the sorted list.
Alternatively, you can sort the landmarks via the landmarks management menu:
1. Press and hold the Down arrow to access the Settings menu.
2. Use the Left and Right arrows to access to the item Landmarks and Routes and press
Confirm.
3. Use the Left and Right arrows to access to the item Landmarks Management. Use the
Up and Down arrows to select the category under which you wish to sort your landmarks
and press Confirm.
4. In the Landmarks Management menu, use the Left and Right arrows to access to the item
Sort and press Confirm.
3.7 Routes
The StellarTrek provides the user with an opportunity to record a route while walking it a first time.
This way, it is possible to select the most secure or preferred path. The created route can be named
and retraced to be used at a later moment. Please note that recorded routes are only available in
pedestrian mode.
3.7.1 Recording a Route
To create a route:
1. Press and hold the Record button and press Confirm to start creating a route. The
StellarTrek will ask you to record a route name.
2. After the beep, you will have 4 seconds to describe the route. You may find helpful to name
the route by its origin and destination. For example, “Home to pharmacy”.
3. When the StellarTrek has confirmed that you are creating a route, navigate the entire
course of the route. The StellarTrek will emit a beep every 60 seconds to indicate the
recording of the route.
4. Note that you can create landmarks along the way. To do so, press the Record button.
After the beep, you will have 4 seconds to provide a vocal description of the landmark. A
second beep will indicate the end of the landmark creation, at which point you can continue
your route.
5. When you have reached your destination, press and hold the Record button until you hear
the beep, to inform the StellarTrek that the destination has been reached. The beeping
stops and a message informs you that route recording has ended.
Important: You cannot record routes when in a vehicle. If you enter a vehicle during the route
creation, please note that that your route may not be valid. Please preview before using this route.
3.7.2 Indoor Preview of a Route
The StellarTrek allows you to preview a route before navigating it. This gives you a chance to learn
the route instructions ahead of time. Indoor preview will provide you with detailed intersection
information and turn instructions.
To Next Page
Loading...