2.3.5 Forget a Bluetooth Device
If you wish to unpair the StellarTrek with a Bluetooth device, select the Paired Devices item. Upon
selecting this sub-menu, the StellarTrek will display the list of all the Bluetooth devices you are
paired with. Navigate to the device of your choice using the Left and Right arrows, then use the
Up and Down arrows to access the item “Forget device”. Press Confirm to unpair with it. You will
receive confirmation once the device is forgotten. Note that the device will remain discoverable in
the Pair New Device submenu.
2.3.6 Display Information on a Connected Device
You can display information on the Bluetooth devices connected to the StellarTrek, such as their
MAC address or their battery level. To display a device information, navigate to the item Connected
devices in the Bluetooth menu and press Confirm. Use the Left and Right arrows to navigate to
the connected device of your choice and press Confirm to read the device information.
2.4 Wi-Fi
To configure the Wi-Fi settings on the StellarTrek device, you first need to access the Wi-Fi menu:
1. Press and hold the Down arrow to access the Settings menu.
2. Use the Left and Right arrows to access the item Wi-Fi and press Confirm.
The menu contains the following items:
• Toggle Wi-Fi on or off
• Network Status
• Scan Available Networks
• Display Saved Networks
• Enter Network Manually
2.4.1 Toggle Wi-Fi
In the Wi-Fi Settings menu, use the Left and Right arrows to navigate to the Toggle Wi-Fi item.
Press Confirm to toggle the Wi-Fi on or off.
Note that it is recommended to turn the Wi-Fi off to preserve your battery if you don’t intend to use
Wi-Fi.
2.4.2 Network Status
If you are connected to a Wi-Fi network and wish to know its status, use the Left and Right arrows
to navigate to the Network Status item in the Wi-Fi settings menu. The StellarTrek will announce
the name of the network and the quality of the signal. Press Confirm and the StellarTrek will
announce further information on the network (SSID, signal strength, MAC and IP addresses, Wi-Fi
frequency).
2.4.3 Scan Available Networks
To connect to a Wi-Fi network, you must launch a scan to generate a list of all the available Wi-Fi
routers within range of your StellarTrek.
In the Wi-Fi Settings menu, use the Left and Right arrows to navigate to the Scan Available
Networks item and press Confirm. Use the Left and Right arrows to browse the available router
SSIDs that were found. Press Confirm to select the router you wish to connect to.
You will then be prompted to enter the password for the chosen router. Note that passwords are
case sensitive. You may toggle between uppercase, lowercase, and numeric. Refer to section 2.2
To Next Page
Loading...