Note that you cannot install new maps if the device needs a software update.
Maps are divided in levels: Continent, Countries, and the Regions included in a country, if
applicable.
Level 1 (Continents): Continents is the most general map level (North America, South America
Europe, Africa, Oceania, Middle East). Use the Left and Right arrows to scroll through the
available continents maps, and press Confirm to browse a continent.
Level 2 (Countries): The maps of each country included in a continent will be available. Use the
Left and Right arrows to scroll through the available Countries maps, then press Confirm to
browse the map of a Country and select the maps of certain of its regions or provinces. If you wish
to select an entire country, press the Up or Down arrow to reach the item Select and press
Confirm. If you wish to unselect a map, press the Up or Down arrow to reach the item Unselect
and press Confirm.
Press Back to go back to the list of Continents.
Level 3 (Regions, if applicable): When they are available, regions included in the selected country
will be listed after the country name. Regions often cover provinces or states. You will be prompted
with the map status (“Selected” or “Unselected”). Use the Left or Right Arrow until the wanted
region is announced. The StellarTrek will prompt the state name and the new selection status
(“Selected” or “Unselected”). Press the Confirm button to select/unselect the region. Press Back
to go back to the list of Countries.
When you are done selecting your maps, press the Go To button to accept your changes or the
Back button to discard them and leave the menu. After pressing the Confirm button, your newly
selected maps will be installed, whereas unselected maps will be deleted, freeing some internal
memory. The device will describe the changes to be made, including the space freed or to be taken
and will prompt for confirmation.
Note that if a map needs to be updated, it will be automatically updated when the device proceeds
to a software update (see section 7 for more details).
2.6 Time & Device Status
When connected to a Wi-Fi signal, and with the GPS position known, the StellarTrek will configure
the time automatically.
If you wish to know the time, along with the battery level and the GPS signal quality, you can do so
by double-pressing on the Down arrow.
It is also possible to change the time format, from 24 hours to 12 hours, or vice-versa, by doing the
following:
1. In the Settings menu, use the Left and Right arrows to access the item System and press
Confirm.
2. Use the Left and Right arrows to access the item Regional Settings and press Confirm.
3. In the Regional Settings menu, use the Left and Right arrows to access the item Time
Format.
4. Press Confirm to toggle the time format of the device.
To Next Page
Loading...