3. The StellarTrek will ask you to select the country, state/province in which you will be
travelling. The available choices depend on the maps you have installed. Use the Left and
Right arrows to make your selection, followed by Confirm.
4. You must now enter the name of the city. The previous city name entered will be
announced. If you wish to select this city, or if none have been previously entered, you will
need to enter the city name using the virtual keyboard (see section 2.2) or press and hold
the Voice button to dictate the name . Enter the city name and press Go to.
5. Select a name from the list of possible choices and press Confirm.
Note: You don’t need to enter a complete city name or street name. You can enter a partial name,
followed by Go to and the StellarTrek will search for names that include the characters entered.
Use the left or right arrows to browse the list of names and press Confirm to make your selection.
6. After entering the city name, you must enter the street name. Proceed using same method
as for entering city name. You can press the Back button to return to the previous level.
7. Once a street name is entered, you will be asked for a civic number. If you know the exact
civic number, again, type the address number, followed by Go to.
If the civic number you entered does not exist, the StellarTrek will provide a list of address
ranges for that given street, followed by a list of intersections where address ranges are
not available. Use the Left and Right arrows to browse the list, and press Confirm to make
your selection.
At this point, a new landmark will have been created for this address; it will be added to the
list of landmarks, and can now be selected to begin a new route (see section 3.8).
Note: During the character entry process, you can press and hold the Left arrow at any time to
delete a character. If you wish to return to the previous entry level, press Back. To have your
current entry repeated and spelled to you, press the Voice button.
3.10 Getting Guidance to a Postal Code (UK and Netherlands
users only)
When browsing the list of possible landmarks towards which you can be guided, (see section 3.8)
you will come across an option allowing you to enter a postal code. This section will provide
information on how to use the StellarTrek’s buttons to enter postal code details, similarly to entering
an address (see section 3.9).
To have the StellarTrek guide you to a postal code:
1. Press the Go To button. This will take you to the list of landmarks you can use as possible
destination.
2. Use the Left and Right arrows through the list of landmarks and select Enter a postal
code. Press Confirm to select this option.
3. The StellarTrek will ask you to enter the postal code towards which you will be travelling.
You need to enter all characters, either letters (capital and/or lowercase) or digits, of the
postal code, with or without spaces. It is also possible to dictate the postal code by pressing
and holding the Voice button. When it is complete, press go to. The StellarTrek will repeat
the entered postal code.
4. You must now enter the civic number of the street you want to be guided to, either by typing
the name or by dictating it.
Note: Entering a civic number after the postal code gives a more accurate location for the
destination since in some cases, for instance in rural areas, a single postal code may cover a large
geographical area.
To Next Page
Loading...