1.6 Getting Started
Upon activating the StellarTrek for the first time, you will need to go through a setup wizard to
configure the device:
1. If the battery level is below 25%, the StellarTrek will prompt you to charge the device.
Charge it for at least 30 minutes before trying again.
2. You will be prompted with a language selection menu. Use the Left and Right arrows to
navigate through the list and press the Confirm button to select the language in which you
want to operate the device.
3. You will then be prompted with a keyboard layout selection menu. Use the Left and Right
arrows to navigate through the list and press the Confirm button to select the keyboard
layout of your choice (see section 2.2.1 below for more details).
4. The device will prompt you to setup Bluetooth devices (see section 2.3 below for more
details).
Note that you can skip this step by using the Left and Right arrows until you reach the
item “Proceed to next step” pressing the Confirm button.
5. You will be asked to setup the Wi-Fi (see section 2.4 below for more details).
Note: you can skip this step by using the Left and Right arrows until you reach the item
“Proceed to next step” pressing the Confirm button. It is recommended, however, to
connect to a Wi-Fi network to install updates and maps.
6. If an update is available, the StellarTrek will prompt you to install it by pressing Confirm.
7. The StellarTrek will ask you to install maps (see section 2.5 for more details).
8. The device will present information about the key describer mode and additional settings.
Press the Confirm button to start using the device.
Note that any setting made during the setup process can be changed in the Settings menu (see 7
for more details).
To Next Page
Loading...