the Left arrow to navigate previous instructions. When in Explore mode, pressing the Right arrow
will announce the next intersection you will encounter if you continue in the same direction.
3.5.4 Repeat Previous Messages
If you wish to hear the last message or instruction again, press the Voice button. If you wish to
hear one of the previous messages, you can press the Left arrow to navigate in the list of the last
5 messages announced by the device. If you want to have the names of the cities or streets spelled
in those messages, you can press the Up and Down arrows.
3.5.5 General Information
You can obtain information regarding various aspects of the route and the system by pressing the
Down arrow.
Press the Down arrow to obtain contextual information on the current StellarTrek activity. You will
be given the following information: ON or OFF route, route name, Distance remaining, Distance
traveled, and Route length.
Press Right arrow to obtain speed information.
3.6 Record Landmarks
Users can create landmarks any time along their outdoor environment. These act as reference
points or markers and will be detected when the user comes across them. It is highly recommended
to mark any meaningful point in your surrounding that can act as a guiding element, an obstacle
along the way or a possible destination.
To record a landmark:
1. Press the Record button.
2. After the beep, provide a 4 second description of the landmark. A second beep will indicate
the end of the landmark creation. The description and location of the landmark will be saved
by the StellarTrek.
Note that it is possible to cancel the recording of a landmark by pressing the Back button. The
recorded landmarks are kept in the list of possible destinations.
Important: Before recording landmarks, press the Where am I button to make sure that the
StellarTrek has properly located your position. If the landmark is meant to be situated at an address,
make sure the StellarTrek recognizes the location as a position on that Street (and not an open
area). Similarly, if the intended Landmark is meant to be in an open area, make sure the StellarTrek
does not recognize the location as being linked to streets.
3.6.1 Set a Point of Interest as a Landmark
You can save a commercial point of interest as a landmark, to which it will be possible to be
guided:
1. Press and hold the Where Am I button to display all the points of interest near your
position (see section 3.5.2).
2. Use the Left and Right arrows to select the point of interest you wish to save as a
landmark.
3. Use the Up and Down arrows to reach the item Set as a possible destination and press
Confirm.
To Next Page
Loading...