Press and hold Where Am I to hear any nearby Points of Interest.
Press the Record button to create a new landmark at your current map browsing location.
To exit Map Browsing mode, press Back. You will then be prompted asking if you wish to exit this
mode. Press Confirm to exit, or any other key to remain in Map Browsing. Upon exiting, the
StellarTrek will return you to Explore mode.
3.12 Locking/Unlocking Open Area
If you are walking in a park, university campus, or doing outdoor hiking, the StellarTrek can ensure
you remain in open area without automatically placing you on a nearby street. To do so, simply
press and hold the Right arrow. You will hear a beep sound and the StellarTrek will announce
“Entering open area locked”. If a route is activated, deactivate it first by pressing the Back button
before locking open area.
In open area locked mode, you can be guided as the crow flies towards any personal point of
interest or landmark, whether your destination has been created on the road network or in an open
area.
To leave open area locked, press and hold the Right arrow again. The StellarTrek will announce
“Leaving open area locked” and will automatically recognize whether you are in an open area or on
a street.
3.13 Landmarks and Routes Configuration
To configure the landmarks and routes on your StellarTrek, access the Settings menu by pressing
and holding the Down arrow, then use the Left and Right arrows until you reach the item
Landmarks and Routes and press Confirm.
A submenu will appear, displaying the following options:
• Landmarks management
• Export landmarks and routes
• Import landmarks and routes
3.13.1 Configuring Landmarks=
To configure a landmark on your device, use the Left and Right arrows until you reach the item
Landmarks Management and press Confirm.
Use the Left and Right arrows to select the landmark you wish to configure.
Use the Up and Down arrows to select the operation you wish to perform on the landmark.
Operations include:
• Set/Unset landmark as possible destination
• Delete landmark
• Rename landmark with audio
• Rename landmark with text
Press Confirm to trigger the selected operation.
Note regarding Landmark configuration: You can directly access Landmark Settings. To do so,
press the Go To button, then select a landmark with the Left and Right arrows. Use the Up and
Down arrows to select the operation you wish to perform on the landmark.
To Next Page
Loading...