To preview a route indoors without being interrupted by GPS information:
1. Activate the route. To do so, press and hold the Go To button and use the Left and Right
arrows to browse among available routes. When the route you are looking for is
announced, press Confirm to load the route in the StellarTrek.
2. Press and hold the Right arrow. The StellarTrek will announce you are in the Indoor
Preview mode followed by the first instruction.
3. You will be able to navigate through all instructions using the Left and Right arrows
without being interrupted by incoming GPS information.
4. To exit Indoor Preview, press and hold the Right arrow.
3.7.3 Activate a Recorded Route
You can use the StellarTrek to guide you along a previously recorded route.
To select a route:
1. Press and hold the Go To button.
2. Use the Left and Right arrows to browse among available routes.
3. When the route you are looking for is announced, press Confirm to start the route. If you
wish to follow the route in reverse direction, press the Up or Down arrow to select the item
Start route in reverse direction and press Confirm.
Along the way, you will be instructed on which direction to take when you come across
intersections. Instructions on street network are given according to hand-side (left/right/go straight).
For example, the StellarTrek could tell you to “turn left on Fleet Street.”
When you enter an open area, a message will inform you. In this case, clockwise orientation is
used to instruct the user on directions to take. For example, the StellarTrek could announce the
following message: “Turn at 10 o’clock. Next instructions in 25 meters.”
Upon reaching your destination, a message will be heard and the route will be automatically
deactivated.
For landmarks created by entering an address and for commercial points of interest on maps, the
StellarTrek will announce the side of the street of your destination.
Similarly to the Indoor Preview of a Route, at any moment during a guidance session, you can have
the StellarTrek announce the next or previous instruction by pressing the Right or Left arrow. You
will be given an instruction indicating a distance and action to be taken.
Pressing the Down arrow will provide route information and options: On or off route, name of the
route, and Speed.
3.7.4 Deviating from Route
If you deviate from your route in an open area, the device will warn you. Press Confirm for the
StellarTrek to provide instructions on how to return to your route.
In this situation, you will always be able to use the Right arrow to get information on upcoming
instructions to return to your route. For example: “In 50 meters, go straight”.
3.7.5 Cancelling a Route
After activating a route, you may cancel navigation at any point by pressing the Back button again.
You will be asked to confirm. If the Confirm button is pressed within 10 seconds, guidance will end
To Next Page
Loading...