If the user finds the battery autonomy has decreased, the device will have to be sent to a certified
HumanWare technician to replace it
Contact HumanWare or your distributor for any repair or malfunction questions.
Service shall only be done by HumanWare or its authorized distributor.
Susceptibility to Interference
There may be temporary degradation of the sound when the StellarTrek is subjected to a strong
radio-frequency field, electro-static discharge or transient electrical noise.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
Industry Canada statements
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
This radio transmitter has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use
with this device. The required antenna impedance is 50 ohms.
Antenna Information:
Model: SRF2W012 : 2.4/2.5 - 4.9/5.8 Ghz 30x6x0.15mm
Antenna w/U.FL cable, 150mm
Type: Dromus Dipole
Connector: U.FL - CH0 Only
Peak Gain (dBi): 3.0 (2.4Ghz) / 4.0 (5Ghz)
CAN ICES-3 (B)/NMB-3(B)
To Next Page
Loading...