Installation 13
Installing the MVP ICON Dashboard Software
The MVP ICON Dashboard Software is included with the MVP ICON system and is loaded onto a
CD for installation. It is also available on the BioControl Web site at www.biocontrolsys.com
.
Contact BioControl Technical Support for more information on downloading software.
Note: Ensure the computer is assigned administrative rights prior to installation.
Installing the software:
• Insert software disc into computer CD drive.
• Follow the Install Wizard prompts by clicking “Next”.
• Connect ICON to computer, when prompted for driver installation.
• Click “Finish” to complete installation and install the desktop icon.
• Launch program from the desktop icon.
Note: When installing virtually on multiple user’s desktop, be sure to copy and paste the
installation folder onto each desktop and perform installation from hereby checking the
“setup.exe” file.
USB Driver Installation for Vista
Vista operating systems may require additional steps when installing USB drivers for the MVP
ICON Dashboard software. The software and drivers are included on the software installation CD
and can also be found on the BioControl Web site at www.biocontrolsys.com
. Users will need
their Customer IKD to log in.
Please follow the steps below for installing USB drivers on Vista operating systems.
• Insert the MVP ICON Dashboard software CD and follow the installation prompts. When
the driver installation prompt appears, select OK.”
• The software will continue its installation process, however, the following message may
appear, “MVP ICON driver did not install correctly. Follow any pending prompts to locate
the driver or review the manual for guidance.” If this message occurs, press “OK.”
• Turn on the MVP ICON instrument and plug into the computer’s USB port. At the “Found
New Hardware” message select, “Locate and install driver software.” Follow the prompts
to locate the driver from the software CD.
If the installation CD is not available, select, “I don’t have the disc, show me other options” and
browse to C: Program Files. Select the “BioControl Systems, Inc.” folder, then select the “Driver”
folder and click “Next” when prompted.
• A pop-up message will appear, “Would you like to install this device software?” Select
“Install.”
• The driver installation process will finish and the associated communications port will be
displayed.
For additional assistance, please contact BioControl Technical Support at 800.2456.0113.
25
To Next Page
Loading...