Humminbird ONIX User Manual

122
Radar Options
Display Range Rings
1. From the Overlays menu, select Range Rings.
2. Tap the menu, or press the ENTER key, to add a check mark to the box.
Display Vessel Icons
The Vessel Overlay allows you to display the vessel icon with other visual information such as the heading line, COG (Course over
Ground), Rate of Turn, and drift limit.
1. From the Overlays menu, select Vessel.
2. Select Show. Tap the on/off button, or press the ENTER key, to turn it on.
3. Tap the menu name, or press the ENTER key, to add a check mark to the box.
Display AIS and MARPA Targets
The Targets Overlay displays or hides AIS targets, MARPA targets, and the Safe Zone. An AIS must be connected to enable AIS targets
on the view. See AIS and MARPA for more information.
1. From the Overlays menu, select Targets.
2. Select Show. Tap the on/off button, or press the ENTER key, to turn it on.
3. Select MARPA and/or AIS, and add a check mark to each box.
4. To display the Safe Zone, tap the menu name, or press the ENTER key, to add a check mark to the box.
Display Navigation Data
Use the Nav Data Overlay to display waypoints, routes, and tracks on the Radar View. See Introduction to Navigation for more
information.
1. From the Overlays menu, select Nav Data.
2. Select Show. Tap the on/off button, or press the ENTER key, to turn it on.
3. Tap the navigation data types, or press the ENTER key, to add a check mark to the box.

Humminbird ONIX Specifications

General

Networking	Ethernet
Waterproof Rating	IPX7
Waypoints	3000
Power Output	500W (RMS)
Frequency	50/83/200 kHz
GPS Receiver	Internal