Humminbird ONIX User Manual

174
Sonar & Navigation
NAVIGATION IN SONAR VIEWS (2D, SI, DI)
T
o mark waypoints and start navigation, the control head must have a GPS fix from a connected or internal GPS receiver. The
n
avigation menus can be accessed from the X-Press Menu, touch screen, and the key pad.
Mark a Waypoint
Cross Touch allows you to mark a waypoint on the Sonar Views using the touch screen or key pad. You can also mark a waypoint at
the vessel position or the cursor position.
Mark a Waypoint at the Vessel Position
Mark a Waypoint at the Cursor Position
Touch Screen
1. Press and hold a position on the Sonar View.
2. Select Waypoint.
Keypad
1. Use the Joystick to move the cursor to a position on
the Sonar View.
2. Press the MARK key twice.
Touch Screen
1. Tap Sonar in the status bar.
2. Select Mark.
3. Select Waypoint.
Keypad
1. Press the MARK key twice.

Humminbird ONIX Specifications

General

Networking	Ethernet
Waterproof Rating	IPX7
Waypoints	3000
Power Output	500W (RMS)
Frequency	50/83/200 kHz
GPS Receiver	Internal