Humminbird ONIX User Manual

142
MARPA
C
ancel Tracking for a Selected Target
1. Select a target from the Radar View, Chart View, or Targets tool.
2. Tap the target name, or press the ENTER key.
3. Select Cancel Target.
Cancel Tracking for all Targets (X-Press Menu)
Use the instructions in this section to cancel tracking from the X-Press Menu.
1. With a Chart View or Radar View displayed on-screen, tap Chart or Radar in the status
bar. Select Info.
OR
Press the ENTER key.
2. Select MARPA: All Inactive.
Cancel Tracking for all Targets (Targets Tool)
Use the instructions in this section to cancel tracking from the Targets tool.
1. Press the HOME key.
2. Select the Targets tool.
3. Select Cancel All MARPA Targets.
Start Navigation to a Selected Target
Start navigation to a selected target using the following instructions. See Introduction to Navigation for more features and
information.
Start Navigation to a Selected Target
Touch Screen
1. With a Chart View or Radar View displayed on-screen,
tap a target to select it.
2. Tap Radar or Chart in the status bar, and select Go To.
3. Select Go To Cursor.
Keypad
1. With a Chart View or Radar View displayed on-screen,
use the Joystick to move the cursor to a target.
2. Press the GO TO key.
3. Select Go To Cursor.

Humminbird ONIX Specifications

General

Networking	Ethernet
Waterproof Rating	IPX7
Waypoints	3000
Power Output	500W (RMS)
Frequency	50/83/200 kHz
GPS Receiver	Internal