11
The Flow-Clik Interface Box is designed to mount next to
the irrigation controller. A door is provided to keep water
and debris from entering the inside of the Interface Box. A
lock is also provided to prevent unauthorized changes in
Flow-Clik settings. There are two mounting tabs on the top
and bottom of the Interface Box to provide an easy means
to secure it on the wall next to the controller. Using the
hardware included, mount the Interface Box to the wall (use
screw anchors if needed). Make sure to place the Interface
Box close to the controller (check that the controller door
and Interface Box door to not interfere with one another).
MOUNTING THE FLOW-CLIK INTERFACE BOX .........................................
To Next Page
Loading...
