Lateral Force Sensor
Lateral Force Sensor calibration requires Kit 20-1693-1. This procedure requires
Form 4886T, 03-03, Calibration Instructions for StraightTrak Kit 20-1693-1.
Contact a Hunter Service Representative for more information.
6.2 Diagnostic Procedures
The balancer is equipped with a series of self-diagnostic tools. Access the “Diagnostics”
primary screen can by selecting “Diagnostics” from the “Logo” screen. As each procedure
is highlighted by selecting “n” or “p,” the equipment components for each diagnostic
procedure are shown in yellow on the illustrated GSP9720JLR.
Most of the diagnostic data is for the sole purpose of conveying information to the
Hunter Service Representative. The service representative may request information
from these screens to diagnose service concerns. The ability to convey diagnostic
data to the representative prior to service expedite repair to the equipment.
Begin each highlighted diagnostic procedure by selecting “Begin Selected Test.” To
exit a diagnostic procedure, select “End This Test.” On many test screens there will
also be an option for printing the test screen.
Force Sensors
Tests both force sensors and displays samples from the last spin. Close hood to
initiate test sequence. Either left or right sensor can be displayed. Other visual
controls that are available are “zoom,” “pan left,” and “pan right.”
GSP9720JLR Wheel Balancer Operation Instructions Calibration and Maintenance
129
To Next Page
Loading...
