Hunter GSP9720JLR - Lowering the Wheel Assembly

Raise the lift control handle “up” to move the lifting assembly into a position where
the wheel assembly can be installed onto the spindle.
Slide the tire/wheel assembly onto the spindle and center on the mounting cone.
Verify that the wheel assembly is centered vertically on the spindle.
TIRE/WHEEL
ASSEMBLY CENTERED
VERTICALLY ON
SPINDLE
SPINDLE
NOTE: Lower wheel lift as needed to clamp wheel, but keep the
wheel lift carriage in place under the wheel assembly.
Clamp wheel onto the spindle.
Keep the wheel lift carriage in place under the wheel assembly and close the hood.
The lifting assembly will automatically lower and park the carriage below.
NOTE: Allowing the balancer to park the wheel lift carriage in place
under the wheel assembly will make the removal and
lowering of wheel assembly easier and quicker.
Lowering the Wheel Assembly
Remove wheel clamp.
Starting with the wheel lift carriage parked under the wheel assembly; raise the lift
control handle “up” to move the lifting assembly to the wheel assembly.
Slide the carriage with wheel assembly to the end of the wheel lift rail.
24
x
Balancing Procedures GSP9720JLR Wheel Balancer Operation Instructions