Static Balancing – Traditional Balancing Mode
NOTE: Enter wheel dimensions before selecting dynamic balancing.
If SmartWeight mode is enabled in setup, the balancer will
return to SmartWeight balancing upon dimension entry.
Static balancing is selected by pointing the indicator to while using the control
knob. Static balancing provides a less desirable balance than dynamic balancing.
Dynamic balancing should be selected whenever possible to minimize vehicle
vibration. Refer to “Balancing Theory-Static Imbalance,” page 13.
Static Balance Mode Reminder (Except Patch Balance)
Two reminder pop-up text messages appear on the balance screen dialog box when
selecting static mode. The first screen gives the warning: “Avoid STATIC single-plane
balancing.”
The second screen suggests: “DYNAMIC dual-plane balancing recommended (even
for hidden weights).”
48
Balancing Procedures GSP9720JLR Wheel Balancer Operation Instructions
To Next Page
Loading...
