6. CALIBRATION AND
MAINTENANCE
6.1 Calibration Procedures
Quick Calibration Check Procedure
Quick Cal™ Check can be performed from the “Logo” primary screen immediately
after initial boot-up or after a reset is performed. It provides a quick way to check the
calibration of the force sensors used for balancing.
NOTE: Quick Cal™ Check does not check the calibration of the
Dataset® arms, or load roller.
The weight used for calibrating the balancer and the inner Dataset® arm is stored on
the back of the monitor support.
GSP9720JLR Wheel Balancer Operation Instructions Calibration and Maintenance
119
To Next Page
Loading...
