Display Language
Selects the language for displays.
Print Language
Selects the language for printouts.
Printer
Sets up the correct printer. The current default printer is the Hewlett-Packard DeskJet
(with color reports).
Printout Paper Size Selection
Selects the correct size paper for printouts.
QuickMatch
QuickMatch can be disabled, enabled, or enabled with the toggle key.
Use Runout & Road Force Limits
This set up choice will allow the operator to enable or disable Runout & Road Force
limits.
Hood Autostart Feature
Enables or disables automatically starting the spin upon closing the hood.
Servo-Stop
Enables or disables the intelligent DC motor drive to automatically rotate the wheel to
the weight or ForceMatch Mark positions. Servo-Push may also be enabled, which
allows pushing the wheel (approximately 1/8 of a revolution) to cause the intelligent
DC motor drive to automatically rotate the wheel to the next weight or ForceMatch
Mark positions. Pressing the “START” key may still be used for this function.
Balance Checkspin
Enables or disables the load roller during balance verification spins. When enabled
the load roller will automatically disabled as necessary.
Weight Units
Use “Weight Units” to select English or Metric units for displaying wheel weights.
NOTE: Balancer must be in service mode to view/change the
remaining set-up items: Set Date and Time, Prompt To Set
Date and Time, Balance Limits, Prompt for Wheel Assembly
ID and Spindle Type. Refer to “5.4 Service Mode Setup and
Features” on page 114.
Inflation Station Units
Selects English or Metric units for air pressure, or disable the option altogether.
Runout Units
Selects English or Metric units for displaying runout measurements.
Road Force Units
Selects the desired units for road force measurement to be displayed on the screen
and in printouts. Select units in pounds, Newtons, or kilograms.
GSP9720JLR Wheel Balancer Operation Instructions Equipment Information
113
To Next Page
Loading...
