6.5 Maintenance
Spindle Hub Face and Shaft
Keep the shaft and wing nut threads clean and lubricated. Lubricate the shaft without
contaminating the hub face. Select “Clean Spindle Threads” from the “Balance”
primary screen. Run the edge of a rag between the threads while the spindle is
slowly turned by the motor drive. If any signs of dirt or debris appear on the spindle
threads, the spindle should be cleaned immediately prior to mounting a wheel.
CAUTION: Failure to clean spindle properly will result in a loss of
clamping force. Due to the force applied to the wheel by the
load roller, it is critical to maintain optimum clamping force.
Lubricate the shaft with a coating of light lubricant with Teflon® such as Super Lube®
by Loctite after cleaning. Do not lubricate the spindle hub face mounting surface. This
could cause slipping between the wheel and the hub face. Keep the hub face
mounting surface clean and dry.
BDC Laser Adhesive Weight Locator Maintenance or Service
CAUTION: Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
This Laser Product is designated as Class 1M during all procedures of
operation.
Never look directly into the laser. Doing so may cause serious injury.
Do not intentional use a reflective device to enhance or re-direct the laser.
Do not operate the laser if the cover or seal is damaged.
There is no required maintenance or service to keep the BDC Laser in compliance.
Any necessary repair or maintenance should be done by the factory only. The BDC
Laser Locator has no field serviceable parts.
The unit should never be opened or modified.
Optional HammerHead™ TDC Laser Clip-On Weight Locator
Maintenance or Service
CAUTION: Use of controls, adjustments, or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
This Laser Product is designated as Class 2M during all
procedures of operation.
Do not stare into the beam or view directly with optical
instruments. Doing so may cause serious injury.
Do not intentionally use a reflective device to enhance or re-
direct the laser.
Do not operate the laser if the cover or seal is damaged.
GSP9720JLR Wheel Balancer Operation Instructions Calibration and Maintenance
131
To Next Page
Loading...
