4.10 Printouts
Balance and loaded runout screens have “Print Summary” and “Save ‘Before’
Measurements” keys on the last key row. The printout combines data from the
balance, loaded runout, and diagnosis explanation (if it exists) screens, replacing up
to four screen prints with one much faster formatted output.
Press the “Save ‘Before’ Measurements” key to save the balance, loaded runout, and
runout measurements for later printing along with measurements after balancing.
NOTE: “Before” measurements are retained only as long as power
is left on.
Imbalance condition, static vs. dynamic, and balance weight types are printed. Split
and Spoke weight values are printed as the single weight equivalent (better indication
of imbalance since weight angles are not printed).
Tire runout and rim runout are not printed on the main printout page. If this
information is desired, printing while in service mode will produce an additional page
duplicating the charted information on the “Show Details” screen through fourth
harmonics.
NOTE: Printed summaries of the savings due to SmartWeight are
available. Refer to section “2.7 SmartWeight Odometer” on
page 19.
GSP9720JLR Wheel Balancer Operation Instructions Road Force® Measurement Procedures
105
To Next Page
Loading...
