If STATIC is selected, the reminders show up again at the end of the spin, and if in
clip-on weight mode, the dynamic weights are shown momentarily, and then the
static weight is displayed.
3.16 Balancing Procedures for Specific Weight Types and
Placement
Press to change the weight types and placement. The GSP9720JLR offers
Standard Balance, Mixed Weights Balance, Adhesive Weights Balance, and Patch
Balance
£
for dynamic and static modes.
With these four selections, a correction weight can be placed at an infinite number of
locations, based upon the choice of the operator.
AUTO MODE DETECTION is the default setting automatically choosing the correct
type of weights and locations determined by the placement of the Dataset® arms.
STANDARD BALANCE should be selected when clip-on weights can be used for
both rim flanges.
MIXED WEIGHTS BALANCE should be selected when a clip-on weight can be used
on the inner rim flange, but not on the outer rim flange. Mixed Weights Balance uses
an adhesive weight for the right weight plane instead of a clip-on weight to avoid
marring aluminum rims or to hide weights from view.
ADHESIVE WEIGHTS BALANCE should be selected when clip-on weights cannot
be used on either rim flange.
GSP9720JLR Wheel Balancer Operation Instructions Balancing Procedures
49
To Next Page
Loading...
