16
®
Repeat the sequence above to enter an Operator’s
PIN number. You are not required to enter a
second level of password protection. If you do not
want an Operator level, simply press ENTER at
this display without entering anything.
If the second (verification) entry of either
Supervisor or Operator level PINs results in an
error, no PIN has been created.
You may change the passwords at any time, but
you must first log on to the controller with the
existing Supervisor-level PIN. If you forget
your PIN, you can clear the password settings.
Contact your distributor or Hunter Field Ser-
vices for help to clear the password settings.
When you press the EXIT button at any time on
the keypad, it will exit the function you are in and
return to the next-highest level in the controller.
After you exit all the way back to the normal
time/date display, and press EXIT again, the
display will show “LOGGED OFF”. This means
that a valid PIN must be entered to log back on
before any programming or operations take place
(if PINs are enabled). If you do not log off when
finished, the controller will log off automatically
after 3 minutes of no activity.
When the PIN settings are complete, press
ENTER. The display will flash “SAVED!” and
your selection. After a moment, the display will
revert to:
You may now press the OPTIONS, BACK, or
NEXT buttons to view more options, or you may
press EXIT to leave the Edit Settings mode.
Writing a Field
Controller Program
Press the PROGRAM SELECT button. The
display will show:
This indicates that you are in Program # 1,
with 0 out of 64 total Programs in use. The
numbers may vary if there are already pro-
grams in the controller’s memory. There may
already be a program name in place of the
dashes. You can edit any Program at any time.
For now, we will work on Program 1 as the
controller came “out of the box”.
Naming a Program:
Press the OPTIONS button. The display will
show “Edit Prg Name”?
Press ENTER. The bottom line of the display
will show “Alpha entry mode”, and the cursor
will be flashing on the first space.
Use the buttons on the keypad to type in a
name for the Program. You may mix letters and
numbers to create accurate names for each
Program (up to 10 total characters long).
Typing Instructions:
Each number button also has a series of letters
of the alphabet assigned to it. While the display
says “Alpha entry mode” the buttons will type
letters only. Press the button rapidly to display
the letter you want. If you release the button
for more than about 1 second, the letter will be
selected and the cursor will advance to the next
position.
To type the word “TEE”, for example, press
the “T” button (#8) once, and wait for a sec-
ond. You may hear a faint beep, and the cursor
will advance to the next space.
To Next Page
Loading...
Need help?
General
