28
®
Move an Event: You can also move the data
from one event to another location in a Pro-
gram, if you want a specific station to keep its
run time, but activate in a different order.
In the example above, you might want to move
station #6 (Event #2) to activate after station
#14 (Event #10).
To move an Event, press STATIONS until the
Event you want to move appears in the display.
Press OPTIONS until “Move an Event?” appears
in the display. Press ENTER. The display will show:
Press ENTER (you may also type in a different
Event number). The display will show:
Type the Event # you want to move the data to
(#10, in this example), and press ENTER. The
display will briefly show OK, and revert to the
Move Event? display.
The Event data has been moved. Note that the
other Events move forward to fill the slot
formerly occupied by station #6. No data was
lost. Only the order in which the stations will
activate has changed.
Note: If you try to move an Event # that does not
exist, or try to move an Event to an impossible #,
the display will briefly show ERROR! and return
To Next Page
Loading...
Need help?
General
