37
VSX OPERATING MANUAL
The display will then revert to the Preset Name
display.
To start a Preset: With only the Day and Time
in the display, press the PRESET button until
the Preset you want to trigger appears in the
display. Press START. The display will show:
Press START again, and the Preset will begin
running.
You may start Presets while other Programs are
running, or while Manual station programs are
running. They will not interfere with one
another, unless you electrically overload the
controller. Be careful not to overload the hy-
draulic capacity of the piping when operating
multiple types of Programs and Presets.
Field Controller
Advanced Options
Unlike Program Options, which only apply to the
selected Program, the Field Controller options
apply to the entire Field Controller, or provide
access to special functions. Several of them have
been covered in detail in other sections.
Field Controller level options are accessed by
pressing the Options button on the keypad
when no Program is selected in the display.
The remaining Field Controller options are
covered in detail here.
Remove a Program: This is used to com-
pletely remove, or delete, a specific Program
and all its information from the controller’s
memory. Use it to wipe out Programs which are
no longer needed, or which no longer serve
their purpose.
To remove a Program: Press the OPTIONS
button until the display shows:
Press ENTER. The display will show:
Press PROGRAM SELECT until the name or
number of the Program you want to remove
appears in the display, and press ENTER. The
display will show:
To Next Page
Loading...
