29
VSX OPERATING MANUAL
you to the option. If you only have 12 Events, you
can only move an Event within the 12 numbers.
You cannot have an “empty” Event in the middle
of a sequence. Trying to move to Event #13
would cause the ERROR! message.
Insert an Event: You can insert a new Event in
between existing Events. In the example above,
you might want to insert station #4, with a run
time of 7 minutes, in between stations #8 and
#9 (Events 3 and 4).
Press the STATIONS button to advance to the
Event where you want to insert an Event (Event
#4, in the example). Press the OPTIONS button
until the display shows Insert an Event? Press
ENTER. The display will show:
Press ENTER. The display will briefly show OK!
and will then revert to the Insert Event? option.
You have now created a blank Event at Event #4.
The stations and Event that were at #4 are now at
Event #5, and the rest of the sequence has been
pushed back, to make room for the new Event.
You may now press STATIONS until you arrive at
the blank Event, and fill it in (in this example,
Station #4 with a run time of 7 minutes).
The new Event data has been inserted. Note
that the later Events move back to make room
for the new Event. You have only inserted a
new Event into the Program sequence.
To Next Page
Loading...
