HunterDouglas Applause - Care and Maintenance Procedures; Removing the Shade from Mounts; Basic Cleaning: Dusting and Vacuuming

Care
21
REMOVING THE SHADE (IF NECESSARY)
■
Lower the shade approximately4".
■
While holding the headrail, push
back on the bottom tab of the
installation bracket to release the
bottom edge of the headrail.
■
After releasing the bottom edge,
roll the back of the headrail down
and out from thebracket.
CLEANING PROCEDURES
Hunter Douglas Applause
®
honeycomb shades are made of anti-static, dust-resistant fabric
which repels dirt and dust. For most fabrics, the following cleaning options are available.
Dusting
■
Regular light dusting with a feather duster is all the cleaning that is needed in most
circumstances.
Vacuuming
■
For deeper cleaning, vacuum gently with a brush attachment.
Compressed Air/Hair Dryer (Cool Setting)
■
Use compressed air or a hair-dryer on a cool setting to blow dust and dirt off shades.
Spot-Cleaning
CAUTION: Do not spot-clean fabric-covered headrail.
■
Prepare a solution of warm water and a mild detergent.
■
Dampen a clean cloth in the solution and wring it out.
■
Dab the spot with the dampened cloth until it is removed. Do not rub the fabric.
■
Allow the shade to dry in the completely closed position.
Headrail
Bracket
Back of
Shade
Remove
Bottom
Tab