Hurco VM10 - Page 109

VM Series Maintenance and Safety Manual 704-0212-209 Record of Changes — 3
704-0212-205, February 2008, ECN 16402
Revised by: K.Gross
Approved by: P. Baechle, F.Gross, D. Ornelas, D. Skrzypczak, February 2008
704-0212-204, August 2007, ECN 16292
Revised by: M. Baechle
Approved by: P. Baechle, D. Ornelas, and S. Kays, July 2007
D. Skrzypczak, August 2007
704-0212-203, 06/29/05, ECN 15925
Revised by: L. Hart
Approved by: P. Baechle, D. Ornelas, D. Skrzypczak, July 2005
Changes
• Added information for VM1P per technical specifications:
VM1P—757-4002-497, Rev B
• Added operation instructions for VM1G Dust Collector.
• Added ATC and Machine Diagnostics, I/O Maps, and Machine Parameters
sections.
• Added Spindle Warm-up and Spindle Run-in sections. Revised for Rev B.
Changes
• Updated information for VM1, VM2, and VM3, per technical specifications:
VM1—757-4002-425, Rev B
VM2—757-4002-426, Rev B
VM3—757-4002-427, Rev B
Changes
• Updated VM1 and VM2 information per technical specifications:
VM1—757-4002-313, Rev C
VM2—757-4002-338, Rev C
• Added VM3 and VM1G information per technical specifications:
VM3—757-4002-357, Rev B
VM1G—757-4002-356, Rev C