Husqvarna EE 5 2021 - Adjusting the Rebound Damping of the Fork; Handlebar Position

11 SUSPENSION SETTING
38
When disconnecting, excess pressure will escape from
the hose – the fork leg itself does not lose any air.
The fork airpump indicator switches off automatically
after 80 seconds.
– Mount the protection cap.
Info
Only mount the protection cap by hand.
Finishing work
– Remove the motorcycle from the lift stand. ( p. 45)
11.14 Adjusting the rebound damping of the fork
Info
The hydraulic rebound damping determines the fork suspension behavior.
F02189-10
–
Turn adjuster
1
clockwise all the way.
Info
Adjuster
1
is located at the upper end of the right
fork leg.
– Turn counterclockwise by the number of clicks correspond-
ing to the fork type.
Guideline
Rebound damping
Comfort 15 clicks
Standard 12 clicks
Sport 10 clicks
Info
Turn clockwise to increase the damping; turn
counterclockwise to reduce damping when the shock
absorber rebounds.
11.15 Handlebar position
M01659-10
On the upper triple clamp, there are 2 holes at a distance of
A
to each other.
Hole distance
A
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance
of
B
from the center.
Hole distance
B
3.5 mm (0.138 in)
The handlebar holder can be mounted in four different positions.
This allows the handlebar to be mounted in the most comfortable
position for the rider.